MARUTI SUZUKI ZEN-Classic Specifications download pdf (Page 71)

79

70F-74E

5) Add just enough specified fluid through

the dipstick hole to fill the transmission

to the proper level. It takes only 0.35

litres to raise the level from “LOW HOT”

to “FULL HOT”.

After checking or adding oil, be sure

to insert the dipstick securely.

Changing Oil

Since special procedures, materials, and

tools are required to change the automatic

transmission oil, it is recommended that you

trust this job to your authorized MARUTI

dealer.

ENGINE COOLANT

Adding Coolant

If the Coolant level is below the “LOW”

mark, more coolant should be added.

Remove the reservoir tank cap and add

coolant until the reservoir tank level reaches

the “FULL” mark. Never fill the reservoir

tank above the “FULL” mark.

• When adding or replacing coolant,

use a high quality ethylene glycol

antifreeze and anticorrosion (Non-

Amine type) diluted with distilled

water. If the lowest ambient

temperature in your area is expected

to be -15

0

C (5

0

F) or above, make the

antifreeze concentration of the

mixture you use at least 30% but no

more than 50%. If -16

0

C (3

0

F) or

below, make the concentration at

least 50%. If the 50% concentration

does not provide adequate

protection against freezing, follow

the instructions on the antifreeze

container to obtain the desired

freezing point.

• When putting the cap on the

reservoir tank, line up the arrow on

the cap and the arrow on the tank,

or coolant can leak out.

Coolant Level Check

Check the coolant level at the reservoir

tank, not at the radiator. With the engine

cool, the coolant level should be between

the “FULL” and “LOW” marks.

INSPECTION AND MAINTENANCE

9-12

ww

ww

w CAUTION

ww

ww

w CAUTION

70F-07-016E

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 102 103

Comments to this Manuals

No comments